Transport And Storage; Transporting The Axial Piston Unit; Transporting By Hand - Bosch Rexroth 3 Series Instruction Manual

22/68

Transport and storage

Dimensions and weights
Bosch Rexroth AG, A4CSG, Series 3x, RE 92105-01-B/06.2017
6 Transport and storage
Risk of damage!
Striking or impact forces could damage the axial piston unit.
▶ Do not strike the coupling or drive shaft of the axial piston unit.
▶ Do not set/place the axial piston unit on the drive shaft.
▶ Do not strike sensitive assembled parts (e.g. sensors or valves).
▶ Do not strike sealing surfaces (e.g. on the suction port or through drive).
▶ Always observe the required ambient conditions for transport and storage, see
chapter 6.2 "Validity of the documentation" on page 24.
Information on unpacking can be found in chapter 7.1 "Unpacking" on page 27.

6.1 Transporting the axial piston unit

The following transportation options are available depending on the weight and
duration of transport:
• Manual transport (chapter not relevant for this axial piston unit)
• Transporting with a lifting device (eye bolt or lifting strap)
Table 6: Dimensions and weights
Size 250
Weight kg 250
Width mm Dimensions vary by equipment. The values applicable for your axial piston
unit can be found in the installation drawing (request if necessary).
Height mm
Depth mm
Weight may vary by equipment. The precise weight can be found on the name plate.

6.1.1 Transporting by hand

Axial piston units with a weight of up to 15 kg can be transported manually for a
short time if necessary.
CAUTIOn
355 500
245 350