Assembly - Master MFG S3O-61-060D-MM Manual

Tools Required: Philips Head Screwdriver, Pliers and Socket Wrench.
Most of the assembly has been completed during the manufacturing process. Only a few short steps are
required to complete your sprayer. Open the shipping carton and remove the contents. Follow the steps below
to assemble your 3-point sprayer:

ASSEMBLY

Step 1) Locate screw holes on front of Sprayer Tank. With
Screws, install Gun Clips to the front of Sprayer Tank. Be
sure open end is facing top of the sprayer.
Step 2) Seat Drain Cap Gasket into Drain Cap. Attach Drain
Cap Tether to Top of Drain Cap. Place other end of Drain Cap
Tether over Drain Port. Thread Drain Cap onto Drain Port.
Step 3) Un-thread Tank Lid from Sprayer Tank. Insert
Tank Lid Tether from bottom of Tank Lid, "T" end
first. Pull Tank Lid Tether through top Tank Lid, so ball
end remains inside the Tank Lid. Thread Tank Lid back
on Sprayer Tank. Thread "T" end of Tether through
hole next to Tank opening.