Flash And Call Waiting; Storing A Phone Number In Memory; Dialing A Stored Number - Uniden EXP2800 Owner's Manual

To locate the handset (while it's off the base), press page/find on the base. The handset beeps for
60 seconds.
Paging is canceled when pressing any key, page/find on the base or return the handset to the base.

Storing a Phone Number in Memory

Your EXP2800 phone has 10 memory locations for storing important telephone numbers.
1) Remove the handset from the base.
2) Press m. The talk/batt LED flashes.
3) Enter the phone number, up to 16 digits. If a pause is needed during the dialing
sequence, press pause to insert a pause. Each pause counts as a digit and
represents a two second delay in time between digits as they are sent.
4) Press m again.
5) Enter the memory location (0-9) on the keypad. A tone indicates that the
number is stored. If you enter a number in a location that has a previously
stored number it will overwrite the existing number without warning.
NOTES: • The pause button counts as one digit. Pressing pause more than once increases the length
of pause between numbers.
• You have 20 seconds after pressing m to enter the number you wish to store. Otherwise, an
error tone will sound.
• You cannot store numbers in m1, m2, or m3.
Using the memory location features
1) Press talk, then press m.
2) Enter the memory location (0-9) on the keypad. The stored number automatically dials.
NOTE: If you select a memory location that does not have a stored number, the handset will beep
rapidly and the phone will not dial.

Flash and Call Waiting

If you have "call waiting" service and a call waiting tone sounds while you are on
a call, press flash to accept the waiting call. There is a short pause, then you will
hear the new caller. To return to the original caller, press flash again.
NOTE: You must subscribe through your local telephone company to receive
Call Waiting Service.

Dialing a Stored Number

Page
6