Canon ELPH Z3 Instructions Manual page 35

Changing the Print Quantity After Taking a Shot
• If you replace the battery, the date and time display on
the LCD panel reverts to "-- -- --" and you cannot specify
the print quantity. When this occurs, set the date and
time before specifying the print quantity.
• Some photo shops may not support the print quantity
specification function. Check with the photo shop
beforehand.
Setting the Mode
Select the Print
quantity mode.
Select the mode for
specifying the print
quantity for the
previous frame.
• Press the
least 2 seconds.
\ "P0" (no prints) blinks on
the LCD panel.
Set the print quantity.
(→ 34 step 2)
Complete the setting.
• Press the
least 2 seconds.
\ The film rewinds 1 frame
and the print quantity
specification for the
previous frame is
replaced.
\ The date/time display
reappears.
button for at
button for at
2
´-35