Uniden EXI3226 Owner's Manual page 36

note
• When reviewing
memory location you
must press a key
within 30 seconds or
the phone will return
to standby.
• If you select "
", no changes
are made and the
handset shows the
" "
screen.
[ 36 ] M E M O R Y F E A T U R E S
5) Press select/vol/ring. The display
shows the memory location you
have selected.
6) Press select/vol/ring again to enter the "
7) The following screen appears, and a cursor flashes
indicating that the display is ready to edit the name.
8) Entering a stored name - "Use the
number keys, /tone/
*
delete/flash to edit the name. (See
page 33) To edit only the phone number, skip this step."
9) Press select/vol/ring. The following screen appears.
A cursor flashes indicating that the display is ready
for the number to be edited.
10)
Enter the phone number with the number keypad (direct entry).
Press delete/flash to remove any unwanted character.
Press and hold delete/flash to clear the entire number.
11) Press select/vol/ring. If you changed either name
or phone number, a confirmation display shows up.
If it is correct, press
select/vol/ring key again. You will hear a confirmation
tone, and the following screen appears.
12) The display then returns to the "
another number to edit (return to step 3) or press memory to return to
standby. To edit a number stored in the base, repeat the steps for storing
numbers in the base. (See page
32.) This will simply overwrite the
number that was previously stored
in the location.
, #/ , or
/int'c and press the
" mode.
" screen. You may select
www.uniden.com