Uniden EXI3226 Owner's Manual page 11

C. Connect the base unit
1) Connect the AC adapter to the DC IN 9V
jack and to a standard 120V AC wall
outlet.
2) Set the base on a desk or tabletop,
and place the handset on the base
unit as shown. Remove the beltclip,
if attached for face up charging.
(For wall mounting, see "Mounting the
Base Unit on a Wall", on page 13 and 14).
3) Raise the antenna to a vertical position.
4) Make sure the charge/in use LED is illuminated. If the
LED is not illuminated, check to see that the AC
adapter is plugged in and the handset makes good
contact with the base charging contacts.
• Connect the AC adapter to a continuous power supply.
note
• Place the base unit close to the AC outlet so that you can unplug the AC adapter easily.
www.uniden.com
• Use only the
supplied AD-314
AC adapter. Do not
use any other
AC adapter.
• Place the power cord
so that it does not
create a trip hazard
or where it could
become chafed and
create a fire or
electrical hazard.
note
The handset can be
placed face up or face
down on the base for
charging.
G E T T I N G S T A R T E D [ 11 ]
!
[ 11 ]