Examples Of Use - Parkside 316730_1904 Operation And Safety Notes

After measurement:
After carrying out the measurement, move the external
measuring jaws 11 / internal measuring jaws 2 together
again by turning the handwheel 7 inwards clockwise .
Switch the LCD display 5 off again by pressing the
ON / OFF key 10 .
Tip: The LCD display 5 automatically switches itself off
after approx . 5 minutes .
Tighten the locking screw 4 again by turning it clockwise
until you feel some resistance .
˜ Examples of use
Tip: When measuring, always proceed as described in the
chapter on using the calliper .
Comparison of plug and socket (see Fig. C):
First measure the dimensions of the plug (see Fig . C .1) .
You may wish to make a note of the measurement .
Then, measure the socket (see Fig . C .2) .
Deviation from a reference value (see Fig. D):
Measure a reference object (in this case A) (see Fig . D .1) .
Leave the measuring jaws 2 / 11 in this position and
press the key to obtain the zero setting (ZERO) 9 .
Then measure the second object (see Fig . D .2) . The LCD
display 5 now shows the deviation of the measurement of
the second object to that of the reference object (A) .
Measuring the thickness of the floor of an object
(see Fig. E):
First measure the depth of the object (see Fig . E .1) .
Leave the depth blade 6 in this position and press the key
to obtain the zero position (ZERO) 9 .
Now measure the entire object (see Fig . E .2) . The LCD
display 5 now shows the thickness of the floor of the
object .
Measuring the distance between two identical
holes (see Fig. F):
First measure one of the two, equally sized holes
(see Fig . F .1) .
Leave the measuring jaws 2 / 11 in this position and
press the key to obtain the zero position (ZERO) 9 .
Now measure the total dimension (see Fig . F .2) . The LCD
display 5 now shows the average distance .
24 GB/IE