Preparing The Machine - Toro 133-7128 Installation Instructions Manual

1

Preparing the Machine

No Parts Required
Procedure
1. Move the machine to a level surface (box A of
2. Engage the parking brake (box B of
3. Remove the key from the ignition switch (box C of
4. Remove the negative battery cable from the battery (box D of
2
Installing the Headlights
Parts needed for this procedure:
2 Headlight
2 Headlight adapter
5 Cable tie
Procedure
1. Remove the existing left and right headlights from the
headlight positions.
2. Install a headlight adapter to each headlight
Figure 1).
Figure 1).
Figure 1).
Figure 1
1
1. Headlight
2. Headlight adapter
(Figure 2).
3. Install the headlights into the front of the machine and
4. Secure the electrical connector on the headlight adapter
2
Figure 1).
3
2
Figure 2
secure them with the existing clips
to the machine wire harness electrical connector with
the cable ties (Figure 3).
4
g035872
3. Cable tie
4. Clip
(Figure 2).