Advertisement
5
Installing the Speed Plates
Parts needed for this procedure:
3
Speed plate
2
Plate-mount bracket
17
Pop rivet (3/16 x 0.92 inch)
Installing the Speed Plates to the Seat
Base Sides
1. On the left side of the machine, measure 51 mm (2
inches) from bottom, left of the seat base side, and
mark this location
(Figure
2. Measure 57 mm (2.25 inches) directly above the
location and mark this location
3. Measure 83 mm (3.25 inches) from the left of the
location marked in step 2, and mark this location
(Figure
11).
4. Measure 80 mm (3.16 inches) from the left of the
location marked in step 3, then measure 299 mm (11.78
inches) directly above this location, and mark this
location
(Figure
11).
5. Measure 83 mm (3.25 inches) from the right of the
location marked in step 4, and mark this location
(Figure
11).
6. Drill a 5 mm (13/64 inch) hole at each of the 4 marked
locations
(Figure
11).
CAUTION
Use caution when drilling the holes into the
seat base sides.
On the Workman GTX Gasoline Utility
Vehicle, the fuel tank resides behind the seat
base side on the driver's side of the machine,
and the battery resides behind the seat base
side on the passenger's side of the machine.
On the Workman GTX Electric Utility Vehicle,
the battery charger resides behind the seat
base side on the driver's side of the machine.
If you drill too far into the seat base sides, you
may damage these components.
11).
(Figure
11).
Left Side of the Machine Shown
1. 83 mm (3.25 inches)
2. 51 mm (2 inches)
3. 57 mm (2.25 inches)
4. 299 mm (11.78 inches)
6
Figure 11
5. 83 mm (3.25 inches)
6. 80 mm (3.16 inches)
7. Drill at these 4 locations.
Advertisement
