Sfp Module Cable Specifications; Two Twisted-Pair Cable Pinouts - Cisco Catalyst Blade Switch 3130 Hardware Installation Manual

Cable and Adapter Specifications

SFP Module Cable Specifications

Table B-3
match the wave-length specifications on the other end of the cable, and for reliable communications, the
cable must not exceed the required cable length. Copper 1000BASE-T SFP transceivers use standard
four twisted-pair, Category 5 (or greater) cable at lengths up to 328 feet (100 meters).
Table B-3 Fiber-Optic SFP Module Port Cabling Specifications
SFP Module
1000BASE-SX
(GLC-SX-MM)
1000BASE-T (GLC-T)
1. Modal bandwidth applies only to multimode fiber.

Two Twisted-Pair Cable Pinouts

Figure B-6
and 100BASE-TX-compatible devices.
Figure B-6
Switch
3 TD+
6 TD–
1 RD+
2 RD–
Figure B-7
Switch
3 TD+
6 TD–
1 RD+
2 RD–
Cisco Catalyst Blade Switch 3130 for Dell and Cisco Catalyst Blade Switch 3032 for Dell Hardware Installation Guide
B-6
lists the cable specifications for the fiber-optic SFP module connections. Each port must
Wavelength
(nanometers) Fiber Type
850 MMF
N/A
and Figure B-7 show the schematics of two twisted-pair cables for connecting to 10BASE-T-
Two Twisted-Pair Straight-Through Cable Schematic
Router or PC
3 RD+
6 RD–
1 TD+
2 TD–
Two Twisted-Pair Crossover Cable Schematic
Switch
3 TD+
6 TD–
1 RD+
2 RD–
Core Size/Cladding Modal Bandwidth
Size (micron) (MHz/km)
62.5/125 160
62.5/125 200
50/125 400
50/125 500
Appendix B Connector and Cable Specifications
1
Cable Distance
722 feet (220 m)
902 feet (275 m)
1640 feet (500 m)
1804 feet (550 m)
OL-13269-01