Installing.the.belt.clip; Connecting.the.base.and.charging.the.handset - Uniden DECT2060 Series Owner's Manual

Installing the Belt Clip
Line.up.the.holes.on.each.side.of.the.handset..To.attach.the.belt.clip,.insert.into.
the.holes.on.each.side.of.the.handset..Press.down.until.it.clicks.
To remove the belt clip,.pull.either.side.of.the.belt.clip.to.release.the.tabs.from.
the.holes.
Connecting the Base and Charging the Handset
) Route.the.AC.adapter.cord.through.the."LOOP".of.base's.back.as.shown.
2) Connect.the.AC.adapter.to.the.DC IN 9V.jack.
CAUTION: To avoid risk of fire and shock, only use the
Uniden.AD-800.AC.adapter.
3) Connect.the.AC.adapter.to.a.standard.20V.AC.wall.outlet..
DO.NOT.use.an.AC.outlet.controlled.by.a.wall.switch..
4) Place.the.handset.in.the.base.with.the.LCD.screen.facing.
forward.
5) Make.sure.that.the.charge.LED.illuminates..If.the.LED.does.
not.illuminate,.check.to.see.that.the.AC.adapter.is.plugged.
in.and.the.handset.makes.good.contact.with.the.charging.
contacts.
6) Charge.your.handset.at.least.5.to.20.hours.before.plugging.
into.the.phone.line.
To DC IN 9V To DC IN 9V
4
Route the cord. Route the cord.
To AC outlet To AC outlet
AC adapter (supplied) AC adapter (supplied)