Table of Contents
Advertisement
ASSEMBLING THE BRUSH
Prepare the carbon shaft, half-shell and wires required, according to use.
1- Place a lock-nut on each half-shell (supplied with the machine. (Fig. 1A)
2- Place a lock-nut on each half-shell..
The wire must be positioned symmetrically.
3- Place the unit on the end of the carbon shaft. (Fig. 1B).
4- Pinch the wire with a second half-shell.
5- Tighten the unit with Torx T20 Allen key and the two screws supplied with the machine (Fig. 1C)
6- Repeat the procedure, with a different of 90° between each shell. Leave approximately 3 cm of space
free at the end for fixing the shaft to the chuck (Fig. 1D).
Do not mount more than 8 wires per brush (max wire length 30 cm).
Fig.1A
Fig.1B
Fig.1C
Fig.1D
Tournevis Torx T10
13
Advertisement
Table of Contents
