EMC Disk Library DL4106 Setup And Cabling Manual page 26

b. Type the following commands, where xxx.xxx.xxx.xxx is the IP address of
the DL server, yyy.yyy.yyy.yyy is the netmask (typically 255.255.255.0), and
zzz.zzz.zzz.zzz is the default gateway of the DL server (as specified by the
customer). For example:
ifconfig bond0 xxx.xxx.xxx.xxx netmask yyy.yyy.yyy.yyy
route add default gw zzz.zzz.zzz.zzz
These commands change the network settings temporarily; they revert to the default setting
after the DL server reboots.
OR
• Configure the network settings by connecting a monitor and a keyboard directly
to the DL server:
a. Log in as dlroot. Refer to the note on page 23 for dlroot login information.
b. Type the following commands, where xxx.xxx.xxx.xxx is the IP address of
the DL server, yyy.yyy.yyy.yyy is the netmask (typically 255.255.255.0), and
zzz.zzz.zzz.zzz is the default gateway of the DL server (as specified by the
customer). For example:
ifconfig bond0 xxx.xxx.xxx.xxx netmask yyy.yyy.yyy.yyy
route add default gw zzz.zzz.zzz.zzz
These commands change the network settings temporarily; they revert to the default setting
after the DL server reboots.
Adding the Disk Library server to the Console
1. Open the Disk Library Console program.
Step 12 continued
Initialize the DL server
24