EMC Disk Library DL4106 Setup And Cabling Manual page 19

Initialize the storage system
The hardware serial number of the storage system, which is located on a label on
the front of the storage system behind the bezel, as shown below:
Serial number
The CX3-Series Core Server Support Products CD that shipped with the storage
system.
We recommend that you install and run the storage system initialization utility on a host but
you can run this utility from the CX3-Series Core Server Support Products CD.
Install the Navisphere Storage System Initialization Utility
Use the CX3-Series Core Server Support Products CD and install the storage system
initialization utility on a host connected to the same subnet as the storage system.
Run the storage system initialization utility on the management host
After the storage system is fully powered up for the first time, you must run the
Navisphere Storage System Initialization Utility to initialize the storage system.
Initialization sets management network parameters and security for the storage
system so that you can manage it over the LAN.
Step 9 continued
A B
Front
17
C D
EMC3400