EMC Disk Library DL4106 Setup And Cabling Manual page 20

Initialize the storage system
1. Before continuing, make sure that the storage system is powered up, that each
SP power light (rear of enclosure) is steady green, and that no amber lights are
blinking.
2. Start the initialization utility:
From the toolbar, select
Start > Programs > EMC > Navisphere > Navisphere Storage System
Initialization
3. Read the license agreement, and accept it by clicking I accept and Next.
The utility automatically scans the subnet for storage systems. When the
discovery operation is complete, the utility lists, by hardware serial number (refer
to the picture for the location of the serial number), all uninitialized and
initialized CLARiiON® storage systems that it found. If the discovery operation
did not find the storage system that you are installing, verify that the storage
system's management ports are properly cabled to the LAN on which the host
resides. The storage system and host must both reside on the same subnet.
4. Select the Disk Library storage system to initialize. In the Uninitialized Systems
list, select the storage system's serial number and click Next.
Step 9 continued
18