Honeywell PX940 Installation Instruction page 7

Pin Signal
3 Start print
4 Feed
5 Pause
6 Reprint
7 +24VDC
8 Power
ground
9 Ribbon/
Media low
6
Type Description
Input Pulse Mode - prints one and only one label
whenever this pin is pulled to ground. Signal
must be de-asserted and reasserted to print
another label.
• Printing starts on HIGH to LOW transition if
format is ready.
• De-assert this signal to HIGH to inhibit
printing.
Level Mode - prints labels continuously when
this pin is pulled to ground. Printing is
disabled when signal is de-asserted. If a label
is printing when de-asserted, printing stops
after the label is complete.
• Assert LOW to start printing if format is
ready.
• De-assert HIGH when current label has
finished printing. Remains de-asserted
while waiting for the next label to be ready to
print.
Input Assert LOW to feed label stock. De-assert
HIGH to stop feeding labels.
Input Assert LOW for 200ms and then de-assert
HIGH to toggle between pause and un-pause
states.
Input Enables Reprint mode via software. When
this mode in enabled, assert LOW to reprint
last label. This input is ignored when reprint
mode is disabled.
Output Power for external devices: +24VDC (±10%)
@ 2A.
Ground +24VDC return.
Goes LOW when the ribbon/media roll
Output
diameter drops below a predefined level,
otherwise Goes HIGH.
Media low is supported only by I-Style.
PX940 Applicator Interface Installation Instructions