Honeywell PX940 Installation Instruction page 3

Installing the Applicator Interface Board
Warning: The installation described in this section must only be
Caution: Follow standard ESD guidelines to avoid damaging the
Follow ESD
Procedures
Caution: Before you begin, turn off the printer and disconnect the
Follow the procedure to physically install Applicator Interface Board in the
PX940 printer.
1. Turn off the printer and disconnect the power cord.
2. Open the media cover.
3. Use the T20 screwdriver to remove the two screws securing the electronics
cover to the inside of the printer base.
4. Close the media cover.
5. Remove the two screws located on the outside of the electronics cover.
2
performed by an authorized service technician.
Honeywell assumes no responsibility for personal injury
or damage to the equipment if the installation is
performed by an unauthorized person.
equipment.
power cord and communication cables.
PX940 Applicator Interface Installation Instructions