Advertisement
5.
Remove the existing two hinges held by four #T10 Torx screw at the bottom
of the printer.
6.
Replace the hinges with the new ones that came with the cutter unit using
the same four #T10 Torx screw.
7.
Fit the cutter unit to the vacant hinges. Make sure that the locking plate
snaps into the groove of the right-hand hinge and that the angled plate at
the bottom of the cutter is inserted under the printer's bottom plate.
PX4ie and PX6ie Cutter Kit Installation Guide
3
Advertisement
Troubleshooting
