3.
Figure 45
Figure 45.
4.
1
Note: The
/
" spacing is ideal, although with
16
larger blades it may not be possible. In such
cases, adjust the guide bearings as far for-
ward as possible to the blade gullets, and still
maintain the proper support bearing spacing
adjustment.
Figure 46.
Figure 46
NOTICE
Make sure that the blade teeth will not con-
tact the guide bearings when the blade is
against the rear support bearing during the
cut or the blade teeth will be ruined.
5.
6.
7.
0.004" is approximately the thickness of a
dollar bill.
8.
9.
NOTICE
Whenever changing a blade or adjusting ten-
sion and tracking, the upper and lower blade
support bearings and guide bearings must
be properly adjusted before cutting opera-
tions.
Note: