Advertisement
Calibration of incline and testing motor.
This illustration will show you how to manually calibrate the
incline motor and test out the drive motor as well.
Press and hold the Quick Start and Stop/Reset button both at the same time until you hear a double
beep.
After you hear the double beep the console will show all 8's as seen in the illustration below.
At this moment press the stop/reset button once.
Advertisement
Table of Contents
Related Manuals for BH FITNESS T4
Summary of Contents for BH FITNESS T4
- Page 1 Calibration of incline and testing motor. This illustration will show you how to manually calibrate the incline motor and test out the drive motor as well. Press and hold the Quick Start and Stop/Reset button both at the same time until you hear a double beep.
- Page 2 When you have pressed the stop / reset button all the 8’s will disappear. Immediately press the quick start button once. Press and hold the incline “UP” button the treadmill will incline up and numbers in top left corner will increase. NOTE: You will notice the 51 on the top left corner that is where your...
- Page 3 Once the treadmill stopped inclining, release the Incline “UP” button. Now press and hold the Incline “DOWN” button the treadmill will decline down and numbers in top left corner will decrease. NOTE: You will notice the 213 on the top left corner that is where your incline level should be.
- Page 4 Proceed by repeatedly pressing the speed + button. You will notice the drive motor will start to slowly move. To properly exit the calibration diagnostics mode and to SAVE your calibration. Press the STOP button then remove the safety key, this will save your calibration settings. Re-install the safety key and the unit will display the normal console menu.
- Page 5 3. Press the quick start button once. 2. T6 Basic/Sport/Pro 4. Press and hold the incline up. 5. When the unit reaches the top 3. T4 Basic/Pro release the incline up. 4. TS5 6. Press and hold the decline down.
Need help?
Do you have a question about the T4 and is the answer not in the manual?
Questions and answers