Installing The Split Tube In Kori-Xr; Installing The Cold Trap In Kori-Xr - Markes International Kori-xr Installation Manual

4.5

Installing the split tube in Kori-xr

Replace the back cover and heated valve shield
Carefully position the split tube (SERUTD-5065)
horizontally into the split cradle
Gently but firmly lower the split cradle cover on
Kori-xr.
The oven cover must be lowered completely to
ensure a good seal.
4.6

Installing the cold trap in Kori-xr

Kori-xr uses a specific 4mm tube trap (U-T1KORI).
This part is not used in any other Markes TD
products
Holding onto the trap as close as possible to the
trap box, gently push the trap into the trap box.
DO NOT APPLY EXCESSIVE FORCE TO THE
QUARTZ TRAP.
If in doubt practice with the trap alignment
tool supplied in the shipping kit.
NEVER SWITCH Kori-xr ON WITH THE TRAP
ALIGNMENT TOOL INSTALLED.
Push the trap in until it passes the o-ring.
Markes International Ltd
T: +44 (0)1443 230935 F: +44 (0)1443 231531 E: enquiries@markes.com
www.markes.com
QUI-1138
Page 26