Cable Connections; Installing The Heated Transfer Lines; Installing The Heated Transfer Line Between Kori-Xr And Unity-Xr Or Unity 2- Cia-Advantage, No Ultra-Xr Configuration (Serasx-5004) - Markes International Kori-xr Installation Manual

ECC Configuration
4.3.3

Cable connections

Connect the power cable (SERZ-0024).
Connect the Kori-xr to the PC with the serial cable (SERZ-0189). If there are no available serial ports on
the PC, use the USB-Serial cable adapter (U-USBSR) provided.
4.4

Installing the heated transfer lines

Kori-xr is supplied with two heated transfer lines. The choice of transfer line used will depend on the
configuration of the thermal desorption system. If the configuration of the system demands that the
sample outlet from Kori-xr enters the desorb side of UNITY-xr (UNITY 2) then transfer line (SERASX-5004)
is used. If the configuration of the system demands that the sample outlet from Kori-xr enters the split
side of UNITY-xr (UNITY 2) then transfer line (SERASX-5031) is used.
4.4.1 Installing the heated Transfer Line between Kori-xr and UNITY-xr or UNITY 2– CIA-Advantage, no
ULTRA-xr configuration (SERASX-5004)
Ensure that Kori-xr is switched off and cool.
Remove the front top cover by pulling it up
vertically.
Markes International Ltd
T: +44 (0)1443 230935 F: +44 (0)1443 231531 E: enquiries@markes.com
www.markes.com
Non-ECC Configuration
QUI-1138
Page 14