Pump And Motor (Kleenscreen Fryers Only) - Vulcan-Hart ERA Series Service Manual

ERA & EBD SERIES ELECTRIC FRYERS - REMOVAL AND REPLACEMENT OF PARTS
PUMP AND MOTOR
(KLEENSCREEN FRYERS ONLY)
1. Drain filter tank of shortening.
2. Open the fryer section doors above the filter
tank drawer.
3. Pull filter drawer out, remove filter tank
assembly and push the tank support arms back
into place under the fryer.
4. Remove splash guard from base frame.
5. Disconnect pump motor lead wire connector.
6. From underneath the fryer:
A. Disconnect flexible line fittings from pump.
7. Remove pump motor assembly from fryer.
F25385 (May 2010)
A. Remove pipe fittings from the pump and
install on replacement pump.
8. Reverse procedure to install and check for
proper operation.
Page 12 of 32