Table of Contents
Advertisement
q Dante [PRIMARY] connector
Dante [SECONDARY] connector
These etherCON (RJ45) connectors allow connection with
Dante devices such as a CL series console using stan-
dard Ethernet cables (CAT5e or better recommended).
For the PC-D series, use RJ-45 connectors that comply
with Neutrik Corporation's etherCON CAT5. For the PC-DI
series, use RJ-45 connectors.
NOTE
To prevent electromagnetic interference, use STP (Shielded
Twisted Pair) cables. For STP cables, use conductive tape to
securely connect the metal portion of the connector to the
shielded portion of the cable.
w NETWORK connector
This is an RJ-45 connector for connection to a computer
via an Ethernet cable (CAT5e or better is recommended).
This is used mainly to monitor and control multiple con-
nected devices from the dedicated "ProVisionaire Amp
Editor" application program.
NOTE
To prevent electromagnetic interference, use STP (Shielded
Twisted Pair) cables.
Speaker connections
For the PC-D series
This product uses four Speakon output jacks (NL4) to con-
nect speakers.
NeutrikNL4 plug
1+
1-
The outputs of this product can be bridged in pairs of two
channels.
Since there are no dedicated outputs for use in bridge mode,
take care to observe the following pin assignments.
1+
1-
NL4 A
2+
2-
1+
1-
NL4 B
2+
2-
1+
1-
NL4 C
2+
2-
1+
1-
NL4 D
2+
2-
2-
2+
SINGLE
BRIDGE
CH A+
CH A+
CH A-
CH A-
CH B+
—
CH B-
—
CH B+
—
CH B-
—
CH A+
CH A+
CH A-
CH A-
CH C+
CH C+
CH C-
CH C-
CH D+
—
CH D-
—
CH D+
—
CH D-
—
CH C+
CH C+
CH C-
CH C-
WARNING
Do not touch the pins of unused channels, or allow
them to short.
High voltage is present even at unused pins.
For the PC-DI series
This product uses Euroblock connectors (7.6 mm 8-pin) for
speaker connections.
Insert the tip of a screwdriver into the square hold located on
the top of the cable insertion opening. Inserting the screw-
driver and lifting the internal spring allows the cable to be
inserted or removed.
The outputs of this product can be bridged in pairs of two
channels.
Since there are no dedicated outputs for use in bridge mode,
take care to observe the following pin assignments.
+
EURO A
–
+
EURO B
–
+
EURO C
–
+
EURO D
–
WARNING
Do not touch the pins of unused channels, or allow
them to short.
High voltage is present even at unused pins.
SINGLE
BRIDGE
CH A+
CH A+
CH A-
CH A-
CH B+
—
CH B-
—
CH C+
CH C+
CH C-
CH C-
CH D+
—
CH D-
—
11
Advertisement
Table of Contents
