Commissioning, Inspec-Steps - Commissioning, Inspection And Maintenance - Viessmann Vitoflame 300 VHG III Service Instructions Manual

Steps - commissioning, inspection and maintenance
Commissioning steps
Inspection steps
Maintenance steps
•
1. Commissioning the system...............................................................................................
• •
2. Checking the burner
• •
3. Checking the oil pressure and vacuum, adjusting the CO
• • •
4. Checking the settings of the air damper servomotor.....................................................
• •
5. Cleaning and testing the flame monitor...........................................................................
• •
6. Installing and adjusting the flame monitor (if available)................................................
• •
7. Shutting down the system
• •
8. Checking the firm seating of electrical connections
•
9. Cleaning the burner........................................................................................................... 10
• •
10. Checking the impeller fixings
• • 11. Checking the flame tube fixings
•
12. Replacing the nozzle.......................................................................................................... 11
• •
13. Checking and adjusting the ignition electrodes............................................................. 12
•
14. Fitting the burner cover on the burner casing
•
15. Cleaning the oil pump filter and replacing it if required................................................. 13
•
16. Replacing the pre-filter element
• •
17. Commissioning the system
• •
18. Checking the oil lines and connections for leaks
•
19. Re-testing the burner and entering the actual values into the report
•
20. Operating and service documents................................................................................... 14
Commissioning, inspection, maintenance
value.................................
2
Page
6
6
8
9
9
5