Selecting A Desired Track/Passage; Program Tracks - Hyundai TRC 788 AU3BS Instruction Manual

Note:
1) To ensure good system performance; wait until the disc tray completely reads the disc before
proceeding.
2) If no disc is loaded into the compartment, or the disc is placed upside down, the display will
show N0 DISC.
PLAYING A DISC
After loading the disc, the unit starts playback automatically.
1) The playback starts from track 1, the "Track 01" indicator is shown on the display. To interrupt
playback, press the PLAY/PAUSE button. The "current playing time" indicator will flash on the
display. To resume playback, press the PLAY/PAUSE button again.
2) To stop playback, press the STOP button, the total number of tracks appears on the display.

SELECTING A DESIRED TRACK/PASSAGE

To select a desired track
• Press the /TUN.+ button repeatedly in stop mode or during play until the desired track
appears on the display.
• Press the PLAY/PAUSE button to start play.
To search for a particular passage during playback (track scanning at high speed)
Press and hold the
passage appears, and then release the button. Playback will start again from this point.
To select a song which track number exceeds 10 (for MP3 disc only)
To select a song/track which number exceeds 10, Press the 10/FOLD./M.+ or 10/FOLD./M.-
button each time to skip forward/backward 10 tracks, then press the
to select desired track. For example: to select the 17th track, press 10/FOLD./M.+ button, and
then the /TUN.+ button six times immediately.
To Select A Desired Folder (for MP3 disc only)
(if the MP3 disc contains more than one folder)
To skip to the desired folder during playback, press and hold the 10/FOLD./M.+ or 10/FOLD./M.-
button for about 2 seconds to skip to next/previous folder.

PROGRAM TRACKS

Programming tracks of disc are possible when playback is stopped. Up to CD 20 tracks /MP3 99
tracks can be stored in the memory in any order.
1) In stop mode, press the PROG./MEM./P-MODE button, the "T-000" will flash and the P01
indicator will be on.
2) Press the CD /TUN.+ or
3) Press the PROG./P-MODE button to enter. The display changes to show P02.
4) Repeat steps 2 & 3 to store other desired tracks until all tracks are programmed.
5) Press the PLAY/PAUSE button to start playback from the first programmed track.
6) Press the STOP button to stop program playback.
To Erase the Memory (Program)
To clear the program, you have two options:
1) Press the STOP button when the disc is stopped, and
2) Open the CD compartment lid, program will be erased.
/TUN.+ button to scan the current playing track at high speed until desired
/TUN.- button to select the first desired track to be programmed.
ENG - 35
/TUN.+ or /TUN.- button
ENG