Table of Contents
Advertisement
10.2
Setting SmartLogger1000 Communications Parameters
•
You can set SmartLogger1000 communications parameters, including Ethernet, RS485, and
NetEco parameters over the monitoring panel or embedded WebUI.
•
This section describes how to set communications parameters over the monitoring panel. For
details about how to set parameters over the embedded WebUI, see the SmartACBox 12-In 1-
Out Smart AC Combiner Box User Manual.
•
The communications parameters are available on only SmartLogger V100R001C00SPC111 and
later versions. The screenshots in this document are from SmartLogger V100R001C00SPC111.
Setting Initialization Parameters
When powering on the SmartLogger1000 for the first time, set initialization parameters such as the
system language, system time, the address search scope for the RS485 port, and Ethernet
parameters on the monitoring panel.
•
After Date&Time is set, the settings are synchronized to all the
inverters connecting to the SmartLogger. Therefore you need
to ensure that the settings are correct.
• When setting Ethernet parameters, set the SmartLogger IP
address according to the rules of the PV plant to ensure that it
differs from any device IP address.
•
Visiting some menus requires account authentication.
Therefore, change the password immediately after setting
initialization parameters to ensure the security of your account.
15
Advertisement
Table of Contents
