Table of Contents
Advertisement
No.
Cable
RS485
4
communications
cable
5
PE cable
6.2
Installing the PE Cable
1. Crimp an OT terminal.
2. Secure the PE cable.
NOTE
• Recommended: Route the PE
cable through the cable hole 1 for
the AC input power cable then to
the ground bar.
•
Connect the PE cable to the
nearest ground bar.
•
Recommended: To enhance the
corrosion resistance of a ground
terminal, apply silica gel or paint.
Installing the Router Cable
6.3
NOTE
This document introduces how to install cables for an SC-RRX230 or SC-RRX280 router produced
by SUN DENSI in Japan.
1. Insert the (two-core white) output
terminal of the factory-installed power
adapter into the DC-IN port of the
router.
NOTE
The SmartACBox is factory-installed with two power adapter output terminals. Select an appropriate
output terminal based on the router type.
Recommended Model or Specifications
Two-core outdoor shielded RS485
communications cable (single-core rigid cable
recommended)
Single-core green outdoor copper cable with an
OT-M6 terminal
2. Remove the network cable bound to the
monitoring compartment, and connect the U02-
GE1/LAN1 connector to the WAN/LAN2 port on
the router.
9
Cross-sectional Area
Range of the Cable
2
0.5–1 mm
2
3.5–22 mm
Advertisement
Table of Contents
