Important - Be Sure To Read This Chapter For Safe Use Of The Equipment - Olympus DP72 Instructions Manual

IMPORTANT
The DP72 microscope digital camera is designed to be connected to a camera adapter mounted on an
Olympus UIS2/UIS series of optical microscope (not applicable to the LB series) for use in recording of
microscopic magnified images at high speed (about 2.5 seconds) and highest resolution while maintaining
high picture quality and high color reproduction. The DP72 incorporates a variety of functions for supporting
image recording under optimum conditions.
When the DP72 microscope digital camera is used with a camera adapter or a microscope from other
manufacturer than Olympus, the optical performance may not be manifested fully.
SAFETY PRECAUTIONS
CAUTION
Never connect or disconnect the interface cable while the standby switch
Otherwise, malfunction may result.
1. Before connecting or disconnecting the interface cable, make sure that the standby switch
OFF.
When connecting the interface cable, push in the connector all the way and ensure that the connector will not slip out
before setting the standby switch
Do not move the computer or apply an impact to it while it is powered ON.
2. The cords and interface cables are vulnerable to bend or twist. Do not apply excessive force to them.
3. To prevent the microscope from toppling down, avoid using microscope attachments that may make the total height of
the microscope above 1 meter when they are attached.
4. When installing the PCIe interface board, be sure to hold it by the edge. Never touch the board surface directly, as this will
lead to malfunction.
The area (IC) of the PCIe interface board very hot during
and immediately after use of the camera. Be careful never
to touch them during and after use.
5. For handling of the computer, refer to the separately provided
"Computer User's Manual."
6. Connect the power cord correctly and ensure that the grounding
terminal of the power supply and wall outlet are properly
connected. If the equipment is not grounded/earthed, Olympus
can no longer warrant the electrical safety performance of the
equipment.
7. Lay out the interface cable so that it does not contact the heat-
generating section such as the lamp housing of the microscope.
1
to ON.
of the computer is set to ON.
of the computer is set to
Hot part