Page 2
(inside) • Sensor gets glucose information. Transmitter • Sends glucose information from sensor to display device. All graphics are representational. Your product may look different. Review the Safety Statement in Using Your G6, Chapter 2 before using your Dexcom...
The last step shows you how to set up the second display device. Do not use both tabs. For other ways to learn how to set up your Dexcom • Watch the tutorial at: dexcom.com/downloadsandguides • Contact your local Dexcom representative for support. Dexcom receiver...
Your smart device Applicator with Transmitter Built-in Sensor Set Up App...
Page 5
Step 1: Set Up App Download and open the Dexcom G6 app Follow on-screen set up instructions When prompted: Consent to Share Data with Dexcom • Send your data to the cloud. This lets you use: • Share: Send your...
Page 6
Serial Number (SN) from: Transmitter box Back of transmitter After you enter your SN, your Dexcom G6 searches for the transmitter. While it is searching, you will not get readings or alarm/alerts. Insert sensor transmitter Follow instructions on page 10-12 in this guide.
Page 7
Step 2: See Using Your G6 Learn how to: • Read your home screen • Use alarm and alerts • Make treatment decisions • Troubleshoot issues Step 3: Optional – Set up Receiver Turn on the receiver by pressing the power button down for 2-3 seconds.
Receiver Applicator with Transmitter Built-in Sensor Set Up Receiver...
Page 9
Take receiver out of box Turn on receiver Press power button for 2-3 seconds. Follow on-screen instructions When prompted, enter your: • Sensor code from the sensor applicator you will insert • No sensor code? See Using Your G6, Appendix A Troubleshooting .
Page 10
Transmitter box Back of transmitter After you enter your SN, your Dexcom G6 searches for the transmitter. While it is searching, you will not get readings or alarm/alerts. You are done with this step when you see this screen: Insert & Attach 1.
Page 11
Step 2: Use Applicator to Insert Built-in Sensor Take applicator with built-in sensor out of sensor box Gather materials: applicator (with code you just entered), transmitter and wipes. alcohol Pick sensor site 18 years and older 2-17 years Avoid bones, irritated skin, tattoos, and areas that get bumped. Use applicator to insert built-in sensor Get sensor applicator and an Wash and dry hands.
Page 12
Clean sensor site with Peel off adhesive backings. alcohol wipe. Do not touch adhesive. Place applicator on skin. Fold and break off safety guard. Press button to insert sensor. Remove applicator from skin leaving patch and holder on. Discard applicator. Follow local guidelines for blood-contacting components.
Step 3: Attach Transmitter Take transmitter out of box Snap in transmitter Clean transmitter with alcohol Insert transmitter, tab first, wipe. into holder. Slot Snap in transmitter. It clicks Rub around patch 3 times. into place. Make sure it is flat and snug in holder.
Page 14
Step 4: Start Sensor on Receiver Wait up to 30 minutes for pairing During pairing: • No readings or alarm/alerts • Always keep receiver within 6 meters of transmitter. Tap Start Sensor to begin 2-hour warmup During warm-up you will not get readings or alarm/alerts.
Page 15
Step 5: See Using Your G6 Learn how to: • Read your home screen • Use alarm and alerts • Make treatment decisions • Troubleshoot issues Step 6: Optional - Set up App Download the app onto your smart device and open it.
Need help?
Do you have a question about the G6 and is the answer not in the manual?
Questions and answers