Table of Contents
Advertisement
10. Slide the CardBus Adapter completely into the PCMCIA CardBus slot. When
11. Continue with "Using the IBM Client Utility to set up your wireless network
Installing the Wireless CardBus Adapter in Windows NT
The Windows NT installation consists of two procedures:
v Installing the Setup program
v Installing the Windows NT driver
Installing the setup program for Windows NT
To install the setup program for Windows NT, do the following:
4
802.11a/b/g Wireless CardBus Adapter: User's Guide
9. Hold the CardBus Adapter so that its 68-pin connector is facing your
computer PCMCIA CardBus slot and that its label is facing up.
the CardBus Adapter is properly inserted, Windows 2000 finds the new
hardware and a beep will be emitted indicating that the installation is
complete.
under Windows XP, Windows 2000, and Windows NT 4.0" on page 9.
1. Make sure that the CardBus Adapter is not inserted in the CardBus slot. If it
is, eject it from the slot.
2. Insert the Installation and User's Guide CD into the computer CD-ROM drive.
3. Click Start → Run.
4. Click Browse and navigate to your computer CD-ROM drive.
5. Double-click the SETUP.EXE file on the Installation and User's Guide CD.
6. Click OK. The InstallShield wizard starts and the Welcome window opens.
Advertisement
Table of Contents
