Table of Contents
Advertisement
11. Continue with "Using the IBM Client Utility to set up your wireless network
under Windows XP, Windows 2000, and Windows NT 4.0" on page 9.
Installing the Wireless CardBus Adapter in Windows 2000
To install the adapter in Microsoft Windows 2000 Professional, do the following:
1. Make sure that the CardBus Adapter is not inserted in the CardBus slot. If it
is, eject it from the slot.
2. Insert the Installation and User's Guide CD into the computer CD-ROM drive.
An IBM welcome window opens automatically.
3. Click Software.
4. Click Install Device Drivers. Continue with Step 5.
If the Welcome window does not open, do the following:
a. Click Start → Run.
b. Click Browse and navigate to your computer CD-ROM drive; then
double-click the SETUP.EXE file on the Installation and User's Guide CD.
c. Click OK and the Welcome window will appear, as shown below.
Continue with Step 5.
5. Click Next.
6. Choose Destination Location and click Next.
Driver and Client Utility files are copied from the CD-ROM onto your
computer hard disk drive. After Setup has finished copying the files to where
they belong on your system, a window opens notifying you that the
installation is complete.
7. Click Finish.
8. Locate an available Type II or Type III PCMCIA CardBus slot on your
computer.
3
Installation guide
Advertisement
Table of Contents
