Test Run - Shop fox W1867 Owner's Manual

Test.Run
Once assembly is complete, test run the machine to
ensure it is properly connected to power and safety
components are functioning properly.
If you find an unusual problem during the test run,
immediately stop the machine, disconnect it from power,
and fix the problem BEFORE operating the machine again.
The Troubleshooting table in the SERVICE section of this
manual can help.
To.test.run.machine,.do.these.steps:
1. Clear all setup tools away from machine.
2. Lock all swivel casters on base stand.
3. Connect machine to dust-collection system or place
covers over inlet adapter ports.
IMPORTANT: DO NOT operate dust collector without
first connecting it to a dust-collection system or
covering an inlet adapter port. Otherwise the lack
of airflow resistance will cause the motor to operate
at full amperage load, which could trip your circuit
breaker or blow a fuse.
4. Press Emergency Stop button in, and connect
machine to power.
5. Twist Emergency Stop button clockwise until it
springs out (see Figure.33). This resets switch so
machine can start.
6. Standing away from intake port, press green "I"
button to turn machine ON. Verify motor starts up
and runs smoothly without any problems or unusual
noises.
7. Press Emergency Stop button to turn machine OFF.
8. WITHOUT resetting Emergency Stop button, try
to start machine by pressing the "I" button. The
machine should NOT start.
— If machine does not start, the Emergency Stop
button is working correctly.
— If machine does start, immediately turn it OFF
and disconnect power. The Emergency Stop button
is NOT working properly and must be corrected
before further using the machine.
Model W1867/W1868/W1869 (For Machines Mfd. Since 11/18)
Serious. injury. or. death. can. result.
from. using. this. machine. BEFORE.
understanding. its. controls. and. related.
safety.information..DO.NOT.operate,.or.
allow.others.to.operate,.machine.until.
the.information.is.understood..
DO. NOT. start. machine. until. all.
preceding.setup.instructions.have.been.
performed..Operating.an.improperly.set.
up. machine. may. result. in. malfunction.
or. unexpected. results. that. can. lead.
to. serious. injury,. death,. or. machine/
property.damage.
Figure.33. Resetting Emergency Stop
9. To test remote control operation,
press green remote button to turn
motor ON. The motor should run
smoothly with little or no vibration or
rubbing noises.
10. Press red remote button to turn motor
OFF.
— If the machine does not shut off
-26-
button.
with the remote control, press
the Emergency Stop button to
turn machine OFF. Refer to
Troubleshooting on Page.43 to
correct any problems with the
remote control unit before further
using it again with the machine.