Controlling The Camera - Huawei 200 Quick Start Manual

Blinking red:
Upgrading Single Chip Micyoco
Faulty detected
Blinking green: remote control is in use

Controlling the Camera

The camera can be controlled from the connected HD video conferencing endpoint or IR remote
control.
When the HD video conferencing endpoint is used for camera control, the video cable and
RS232 cable connection must be configured. In addition the following configurations must be
performed:
For configurations (1) and (2), the camera is also controllable by the Huawei Touch
included with the HD video device: when the device is idle, go to Setting > Camera to
set the Touch for camera control. When in a meeting, choose More
(1) Box 300/600 HD video conferencing endpoints:
1) Log in to the web interface. Under System Settings > Input/Output > Video Input >
CAM IN, select the correct COM port for Serial port, and set Camera type to
CAMERA200.
2) Select the correct video input port under Device Control > Camera Parameters and
configure the default video format to 1080p 60 Hz.
3) Select the local video input port under Device Control > Video Control for camera
control operations.
(2) Box 500/700/900 HD video conferencing endpoints:
1) Log in to the web interface. Under System Settings > Input/Output > Video Input,
select CAMERA200 as the input camera type and configure the Serial port. If you use
the HD-VI to DVI/COM adapter of the HD endpoint for control, select the default value
None for Serial port.
2) Go to Device Control > Video Control > Video Input Source > Mainstream Video
Source to select the video input source.
3) Go to Device Control > Camera Parameters to select the video input port and
configure the video format. By default, the format is 1080p 60 Hz.
4) Go to Device Control > Video Control > Local Camera to select the video input
port and perform camera control operations.
(3) TEX0 HD video conferencing endpoints:
Follow the steps listed for the Box 500/700/900 HD above, but select VPC800 as the
camera type.
9
>
Camera.