Steps
1. Place the DC-in module into the provided slot.
2. Install the (M2x3) screw and connect the DC-in cable to the system board.
3. Fold and align the hinge to the screw holders on the palmrest.
4. Install the two (M2.5x5) and one (M2.5x4) screws to secure the hinge.
Next steps
1. Install the battery.
2. Install the
base
cover.
3. Install the
SD
card.
4. Follow the procedure in
Solid state drive
Solid state drive bracket
Removing the M.2 2280 solid-state drive
Prerequisites
1. Follow the procedure in
After working inside your
computer.
before working inside your
computer.
Disassembly and reassembly
37