Properly Aligning The Charger - Boston Scientific Vercise DB-64126 Handbook

Properly Aligning the Charger

1. Press the power button. The indicator light will
come on again, and the Charger will begin
beeping repeatedly to signal that it is searching
for the Stimulator.
2. Position the Charger over the Stimulator
(Figure 6).
The beeping will stop when the Charger is
partially aligned with the Stimulator. For optimal
charging, make sure the Charger is centered
over the Stimulator.
Charging time may increase if the Charger is not fully aligned with the Stimulator. To fully align the Charger over the
Stimulator, position the bottom curve of the Charger approximately 1 cm lower than the bottom curve of the Stimulator.
If you are having trouble properly aligning the Charger or experiencing longer than normal charging times, see the
"Tips for Properly Aligning the Charger" section of this manual.
Figure 6.
Position the Charger Over the Stimulator
Vercise
92357527-02 Page 15 of 101
Using the Charging System
DBS Charging Handbook
TM