FM Amplifi er CGA 225 Art. No. 325030 Assembly Instructions well this supplementary Assembly Instructions, the Assembly Instructions for the CSE 2800 apply. TRIAX - your ultimate connection...
Contents 1 Safety regulations .......................3 2 General information ....................3 2.1 Scope of delivery ..................3 2.2 Meaning of the symbols used .................3 2.3 Technical data .....................4 2.4 Description ....................4 3 Installation .........................5 3.1 Installing the FM amplifier ................5 3.2 Connecting the FM amplifier ................6 4 Setting the FM amplifier ....................7 5 Final procedures ......................8 - 2 -...
CSE 2800 head-end station which pertain to this module. When working on the modules, please take measures to protect against ESD! General information 2.1 Scope of delivery 1 FM amplifier CGA 225 1 Attenuator (10 dB) 1 HF connection cables 1 CD (assembly instructions) 1 Brief assembly instructions 2.2 Meaning of the symbols used...
For supply voltages and control circuits 2.4 Description FM signals can be supplied to the cable network over the FM amplifier CGA 225. This involves sending the FM signals over an IEC socket to the FM amplifier. To eliminate interference, up to 6 different input frequencies can be lowered with tuneable traps.
You can find the current operating software and the software “BE-Flash” on the website “www.triax.com”. The FM amplifier CGA 225 is designed exclusively for use in the CSE 2800 head-end station. Installation Caution – Ensure the head-end station is mounted so it will not be able to vibrate.
• After installing the module close the locking device in the direction of the arrow (fig. 2). Fig. 2 3.2 Connecting the FM amplifier • After setting the FM amplifier (chap. 4) connect its output to one of the inputs of the quad output collector using the attenuator and the IEC / F cable supplied.
After installing the head-end station, retrofitting accessories or installing modules it is necessary to tighten all cable connections, F terminals and cover screws in order to maintain compliance with current EMC regulations and to ensure a reliable operation. Setting the FM amplifier In order to prevent interference, too high signal levels, e.
Final procedures • Connect output of the FM amplifier to one of the inputs of the quad out- put collector using the attenuator and the IEC / F cable supplied. (fig. 3). • Set the output level required for the cable system with level regulator (Fig.