Use Of The Robot In Closed Areas With No Charging Station; Access To The Menu Via App; Setting The User Menu Via The Mobile Application - AMBROGIO L15 Deluxe User Manual

USE OF THE ROBOT IN CLOSED AREAS WITH NO CHARGING STATION

The start-up of the robot in "closed area" mode is for mowing closed areas that are marked off by the perimeter wire and have
no charging station.
EN
Danger - Attention
Safely stop the robot (see "Robot Safety Stop") and carry it using the handle provided. Do not grab the robot
by the body and always use the handle provided.
1. Position the robot inside the work area at a minimum distance
of 100 cm (39.37 in.) from the perimeter wire and from any
other obstacles.
2. Press the ON/OFF button and wait a few seconds for the robot
to turn on completely. Follow the instructions in the display and
enter the password, if prompted.
3. Connect to the robot using the APP on your smartphone and
select the button
4. Select the "closed area" key.
5. Set the time for the end of the working cycle, and select "OK".
At the end of the working cycle, stop the robot in safe conditions
(see "Robot Safety Stop") and carry it back to the area where the
charging station is located.
Restore the normal functioning of the robot as described in chapter
"INITIAL START UP"
The robot has a built-in Bluetooth device that allows it to be programmed and controlled using a smartphone.
Download the Android and iOS app for your smartphone from the product's website. Start the application and follow the wizard
to pair the Robot to your device.
The factory set PIN is "0000." Change the PIN as soon as possible to make the robot safe.
The application allows you to:
• Change the automatic standard working time.
• Set the operation of the rain sensor.
• Set the departure points to optimally manage the secondary area.
• Change the password.
• Send the Start / Pause / Home command.
• Guide the robot during the cutting.
• Display the status, alarms and any errors of the robot.
Start the application from your smartphone and access the robot programming menu via the "Setup" function.
Follow the introduction containing a summary of the programming functions available. Details of each function are found in
the pages following the flow diagram. The functions marked with (*) are only available on some models. See the "Technical
Specifications" table.
User's manual

ACCESS TO THE MENU VIA APP

SETTING THE USER MENU VIA THE MOBILE APPLICATION

min. 100 cm
(39,37 ")
22
min. 100 cm
(39,37 ")