Advertisement
SERVICE MANUAL
After any adjustment of the rear wheel, you will have to adjust the position of the
side guard accordingly.
You should adjust the side guard at approximately 5 mm from the tyre. It is fixed to
the frame in two points: to the backrest tube with a ring A that can slide along the
same tube; to the plate of support B.
If the side guard is straight, you can decide to modify it or not.
A
When you decrease the rear height, you have to move the side guard up.
1. After the rear height adjustment, remove the bolt and nut C1 C2.
2. Loosen the bolt D, slide the side guard upward even beyond the necessary and
temporarily fix it just enough to let it stay where you position it.
3. Put the rear wheel on and position the side guard at approximately 5 mm from
the tyre and parallel to it. Remove the rear wheel, fix the bolt D and put the rear
wheel back on.
4. While keeping the side guard at 5 mm from the tyre, from the outside of the plate
of support B, mark the point where you will have to drill a new hole (however,
check whether you can use the same hole).
5. To do so, use a pointed tool and let it through the slot of the plate. It is advisable
to mark it in the middle of the slot. If the rear height adjustment is remarkable,
you may need a new side guard.
6. Drill a 5 mm hole on the mud guard where just marked.
7. Countersink the hole.
8. Insert the bolt, washer and nut C1 C2 and fix the side guard.
9. Adjust the brake.
B
When you increase the rear height, you have to move the side guard down.
1. After the rear height adjustment, remove the bolt and nut C1 C2.
2. Lean the side guard on the outside of the plate of support.
3. Loosen the bolt D just enough to move the side guard, put the rear wheel on and
position the side guard at approximately 5 mm from the tyre. Remove the rear
wheel and fix the bolt D.
4. Draw a line on the lower side of the side guard considering that, when finally
assembled, it will lean on the spacer of the plate of support. The side guard can-
not go down beyond that spacer.
5. Remove the bolt D and remove the side guard.
6. Saw the side guard along the line you have just drawn and round off the edge
with a blade of a scissor or with fine sand paper.
7. Assemble the side guard and slightly fix it with the bolt D.
8. Continue following the points 3 to 9 of the adjustment A.
REHATEAM s.r.l.—vicolo Negrelli 5—31040 Castagnole di Paese TV - www.rehateamprogeo.com
SIDE GUARD
Standard rear frame
A
D
B
A
Service Manual EXELLE /EXELLE VARIO 19
B
C1
C2
A
Follows next page
Advertisement
