Replacing The System Board - Fujitsu PRIMERGY RX100 S4 Service Supplement Manual

Replacement routines
4.8

Replacing the system board

V
CAUTION!
There are two versions of the system board D2532 with the part numbers
S26361-D2532-A10 (SAS version) and S26361-D2532-B10 (SATA
version).
The PRIMERGY RX100 S4 server's chassis ID is stored on both the LED board
and the system board. If in the event of failure, the LED board or the system
board which has to be replaced must have the chassis ID rewritten.
Ê Open the server as described in the
Ê Remove all external cables.
Ê Remove the riser card holder with the installed controllers (for a description
see the Options Guide).
Ê Remove the processor (for a description see
processor" on page
Ê Remove the memory modules (for a description see the Options Guide).
Ê Remove all cables which may be connected to the system board.
RX100 S4
section "Preparation" on page
25).
Service Supplement
Replacing the system board
section "Replacing the
17.
29