Replacement Routines; Preparation - Fujitsu PRIMERGY RX100 S4 Service Supplement Manual

4

Replacement routines

V
CAUTION!
Observe the safety instructions in the
et seqq. .
4.1

Preparation

Opening the server
Ê Terminate all applications and shut down the server correctly.
Ê If your operating system has not switched off the server, press the on/off
button.
Ê Pull all power connectors out of the power outlets.
Ê Disconnect all cables on the rear of the server.
Ê Loosen the two knurled screws and pull the server as far as possible out of
the rack.
Depending on how accessible the server is in the rack cabinet, it can make
sense to remove it from the cabinet. You will find a detailed description in the
Options Guide or the Operating Manual.
Ê Loosen the green knurled screw at the server's rear side.
Ê Push the top cover approxiate 2 cm in direction of the server's rear side.
Ê Remove the top cover.
RX100 S4
chapter "Safety notes" on page 11
Service Supplement 17