Replacing The Sas/Sata Backplane - Fujitsu PRIMERGY RX100 S4 Service Supplement Manual

Replacing the SAS/SATA backplane

4.5 Replacing the SAS/SATA backplane
You will find the SAS/SATA backplane only in the hot-plug variant.
Ê Open the server as described in the
Ê Remove all the hot-plug hard disk drives (for a description see the Operating
Manual).
V
CAUTION!
Check if all hard disk drives are uniquely identified so that you can
reinsert them into their original bays.
Ê Remove all cables from the SAS/SATA backplane.
Figure 6: Unlocking the SAS/SATA backplane
Ê Unlock the SAS/SATA backplane by pushing the green levels in direction of
the arrows.
Ê Take out the SAS/SATA backplane.
22
section "Preparation" on page
Service Supplement
Replacement routines
17.
RX100 S4