Removing The Battery Pack; Charging The Battery Pack - Toro PowerPlex 51136 Operator's Manual

Removing the Battery Pack

Press the battery latch on the tool to release the
battery pack and slide the battery pack out of the tool
(Figure 6).
1. Battery latch

Charging the Battery Pack

Important:
Read all safety precautions.
Important:
Charge the battery pack only in
temperatures that are within the appropriate
range; refer to Specifications (page
Note:
At any time, press the battery-charge-indicator
button on the battery pack to display the current
charge (LED indicators).
1. Plug the power cord that matches your power
outlets into the battery charger.
2. Make sure that the vents on the battery are clear
of any dust and debris.
3. Line up the cavity in the battery pack
with the tongue on the charger.
Figure 6
8).
(Figure
1. Battery pack cavity
g194190
2. Battery pack terminals
3. Battery pack venting areas
4. Make sure that the vents on the battery charger
are clear of any dust and debris.
5. Slide the battery pack into the charger until it is
fully seated
7)
1. Charger venting areas
2. Left indicator light
6. To remove the battery pack, slide the battery
backward out of the charger.
10
Figure 7
4. Battery-charge-indicator
button
5. LED indicators (current
charge)
(Figure 8).
Figure 8
3. Right indicator light
g228487
g194423