Payne PA1R Series Installation, Start-Up And Service Instructions Manual page 4

MAXIMUM ALLOWABLE
DIFFERENCE (in.)
A-B
0.5
Fig. 3 — Unit Leveling Tolerances
NOTES:
1. Dimension in ( ) is in millimeters.
2. Hook rigging shackles through holes in base rail, as shown in
detail ''A.'' Holes in base rails are centered around the unit cen-
ter of gravity. Use wooden top skid, when rigging, to prevent rig-
ging straps from damaging unit.
3. Weights do not include economizer. See Table 1 for economizer
weights.
CAUTION:
All panels must be in place when rigging.
B-C A-C
1.0 1.0
Fig. 6 — Rigging Details
NOTE: Drain plug is shown in factory-installed position.
Fig. 4 — Internal Trap Condensate Drain
NOTE: Trap should be deep enough to offset maximum unit static
difference. A 4-in. trap is recommended.
Fig. 5 — External Trap Condensate Drain
MAX
UNIT
WEIGHT
PA1R
lb kg
036 415 188
048 425 193
060 445 202
072 520 236
—4—
DIMENSIONS
''A'' ''B''
in. mm in. mm
73.69 1872 35.00 889
73.69 1872 35.00 889
73.69 1872 35.00 889
73.69 1872 35.00 889
''C''
in. mm
33.35 847
33.35 847
33.35 847
33.35 847