Condenser-Fan Adjustment - Payne PA1R Series Installation, Start-Up And Service Instructions Manual

CONDENSER FAN
Fig. 27 — Condenser Coil Cleaning
Fig. 28 — Cleaning Condenser Coil
Fig. 29 — Propping Up Condenser Coil Top Cover
III. CONDENSER-FAN ADJUSTMENT (Fig. 31)
1. Shut off unit power supply.
2. Remove condenser-fan assembly (grille, motor, and fan).
3. Loosen fan hub setscrews.
4. Adjust fan height as shown in Fig. 31.
5. Tighten setscrews.
6. Replace condenser-fan assembly.
A. Manual Outdoor-Air Damper
If outdoor-air damper blade adjustment is required, see Manual
Outdoor-Air Damper section on page 9.
B. Economizer Adjustment
Refer to Durablade Economizer section on page 12.
Fig. 30 — Separating Coil Sections
Fig. 31 — Condenser Fan Adjustment
—26—