FrSky FAS100S Instruction Manual

Introduction

Thank you for purchasing FrSky Smart Port Current Sensor – FAS100S. It is designed for FrSky Smart Port enabled
system, and can measure Current (A) and Battery Voltage (V) when connected between a Battery and ESC and it
has two temperature sensors. In order to fully enjoy the benefit of it, please read the instruction manual carefully and
set up the device as described below.
Note: All instructions, warranties and other collateral documents are subject to change at the sole
discretion of FrSky Electronic Co., Ltd. For further information, please visit www.frsky-rc.com
and click the support tab for this product.

Specifications

● Dimension: 65mm × 21mm × 18mm (L×W×H)
● Weight: 26g
● Measurement range: 0~100A
● Current consumption: 27mV@5V
● Maximum safe current: 100A
● Maximum battery voltage: 14S
● Compatibility: FrSky Smart Port enabled receivers
● Connector: XT90 Anti spark

Set Up

For more details, please refer to corresponding receiver instruction manual.
To the S.Port of
FrSky receivers
RECEIVER
Warning: Install FrSky Smart Port Current Sensor – FAS100S on any appropriate surface of the airframe
that stays away from water, vibration, or fuel.
Other FrSky S.Port enabled sensors including new Smart Port enabled Variometer Sensor, GPS Sensor, RPM
Sensor, Airspeed Sensor, and so on.
ID Set Up
The default physical ID for this sensor is 07. The ID number could be changed by FrSky Servo Channel Changer.
Please refer to the instruction manual of FrSky Servo Channel Changer for details.
FrSky Electronic Co., Ltd.
Add: F-4,Building C, Zhongxiu Technology Park, No.3 Yuanxi Road, Wuxi, 214125, Jiangsu, China Technical Support: sales4tech@gmail.com
Instruction Manual for FrSky
Smart Port Current Sensor — FAS100S
FAS100S
CURRENT SENSOR-100A
ESC
www.frsky-rc.com
01140087
Measured Range:
TEMS : -20℃~250℃ / -4 F~482 F
Deviation: ±5%
TEMS
To other FrSky
S.Port Enabled Sensor
Contact us: frsky@frsky-rc.com
Bat
FAS100S
CURRENT SENSOR-100A
TEMS
Version
1.0