Overhang; Adjusting Buckle Position - Britax GROW WITH YOU User Manual

In some cases, the vehicle head
restraint can prevent the child
seat head restraint from being
raised high enough to properly
adjust the harness for the fit of
your child. DO NOT force the
child seat head restraint past
the vehicle head restraint. Doing
so could cause the child seat not to perform as intended.
If the location of the vehicle head restraint interferes with
the child seat head restraint, raise or remove the vehicle
head restraint. If the vehicle head restraint cannot be
removed, move the child seat to the upright position or
try a different seating location.

Overhang

Harness Mode
It is important that the
base of the child seat rests
completely flat on the
vehicle seat with no side
overhang. As seen in the
illustration, it is permissible
to allow up to 3 in (7.6
cm) of the base to hang
over the front edge of the
vehicle seat. If the vehicle
seat does not allow enough of the child seat base to
make contact, adjust the recline angle to a more upright
position. Not doing so could cause the child seat to not
perform as intended.
Booster Mode
IMPORTANT:
In booster mode, the base of the child seat must fit
completely on the vehicle seat.

Adjusting Buckle Position

Removing the Buckle
1. Unbuckle the harness
by pressing the release
button and pulling the
tongues.
WARNING!
Overhang is not allowed in booster mode.
GROW WITH YOU User Guide
Harness Mode
3"
23