Table of Contents
Advertisement
INSTALLATION INSTRUCTIONS
The Cellar Management System module consists of an LCD touch screen with an
integrated label printer and barcode scanner. The System features easy-to-use
software and includes a pre-installed database of thousands of wines.
INSTALL THE CELLAR MANAGEMENT SYSTEM
Attach the Cellar Management
System Module to the Wine Vault
Step 1:
Center the template between the left
edge of the wine vault and the digital
temperature display. Align the bottom
edge just above the electrical power
cord cover plate. Use a spirit level to
check horizontal position. Tape template
into place.
Step 2:
Use a center punch to mark the 8 screw
locations. Remove the template.
Step 3:
Open the printer cover and install a
mounting screw in the upper left corner
of the mounting plate.
Step 4
Drill 1/8" pilot holes at the marked
locations.
Step 5:
Fold the CPU away from the mounting
bracket. Do not separate the two pieces.
Step 6:
Secure the mounting bracket to the wine
vault with at least eight screws.
Step 7:
Insert the protruding screw heads on the
mounting bracket into the keyhole slots
on the console. Slide the console
downward to lock into place.
Step 8:
Unlock the CPU and swing the front
panel fully open. Tighten the 4 corner
mounting screws. Close and lock the
front panel.
Step 9:
Connect the power cord to the console.
DO NOT CONNECT THE WINE VAULT POWER
CORD AT THIS TIME.
LOCATE THE FINAL INSTALLATION CHECKLIST (Pub. No. 49-60383) IN
THE LITERATURE PACKAGE. THE FORM MUST BE FILLED OUT
COMPLETELY AND SIGNED BY THE HOME OWNER.
28
Fit screw
heads into
keyhole slots
Tighten corner mounting screws
Advertisement
Table of Contents
