INSTALLATION INSTRUCTIONS
ASSEMBLE WALL AND CEILING PANELS
About the Locking Latches
The wine vault wall and ceiling panels connect
together using an innovative latch built into the
top and right side of the panels. To join the panels,
insert the 5/16" hex key into the access holes.
Turn the hex key clockwise approximately 7/8 of
a turn to lock the connector.
Before You Begin
To avoid scratching or damaging adjacent panels,
inspect panels to be sure all locking latches are
fully retracted before setting them into the base
channels. Insert the hex key into the access hole
and turn clockwise until the latch is fully retracted
and cannot be seen.
Installation Tip
As you join panels, loosen the latch 1/4 turn. This
will allow a slight movement to adjust and align the
panels evenly. When completely assembled, tighten
all latches and install the plug buttons.
Panel Identification
Review the illustrations to identify wall panel
placement. Note that the corner pieces are the
same and not location specific.
10
Note: The
latches are
always on the
top, bottom,
and right side.