Technical Data - ABB ACS355 Quick Installation Manual

Start-up
If the drive power rating matches to the
motor power rating, the drive is ready to
run. If any parameter tuning (acceleration
and deceleration times, maximum and
minimum speeds etc.) is required, see
ACS355 drives user's manual (code:
3AUA0000066143 [English]) for further
information.

Technical data

UL checklist
• The ACS355 drive is an IP20 (UL open
or NEMA 1 type) drive to be used in a
heated, indoor controlled environment.
The drive must be installed in clean air
according to enclosure classification.
Cooling air must be clean, free from
corrosive materials and electrically
conductive dust. See ACS355 drives
user's manual (code:
3AUA0000066143 [English]) for
detailed specifications.
• The maximum ambient air temperature
is 50 °C (122 °F) at rated current. The
current is derated for 40 to 50 °C (104
to 131 °F).
• The drive is suitable for use in a circuit
capable of delivering not more than
100 kA rms symmetrical amperes at
the drive maximum rated voltage.
• The cables located within the motor
circuit must be rated for at least 75 °C
(167 °F) UL-compliant installations.
• The input cable must be protected with
fuses or circuit breakers. Suitable IEC
(class gG) and UL (class T) fuses are
listed in the Technical data section of
the user's manual.
For installation in the United States,
branch circuit protection must be
provided in accordance with the
Quick installation guide – ACS355 7
National Electrical Code (NEC) and
any applicable local codes. To fulfil this
requirement, use the UL-classified
fuses.
For installation in Canada, branch
circuit protection must be provided in
accordance with Canadian Electrical
Code and any applicable provincial
codes. To fulfil this requirement, use
the UL-classified fuses.
• The drive provides overload protection
in accordance with the National
Electrical Code (NEC).